Components
F60: Idle switch
G4: Reference point sensor
G6: Fuel pump
G28: Reference Sensor
G39: Oxygen sensor I
G40: Hall Sensor
G61: Knock sensor I
G62: Engine Coolant Temperature (ECT) sensor
G66: Knock sensor II
G69: Throttle valve potentiometer
G70: Mass Air Flow (MAF) sensor
G74: CO Potentiometer
G98: Exhaust Gas Recirculation (EGR) temperature sensor
G108: Oxygen sensor II
J176: Fuel pump relay
J192: Engine Control Module (ECM)
N: Ignition coil for cylinders 1 and 6
N18: EGR frequency valve
N30: Fuel injector, cylinder 1
N31: Fuel injector, cylinder 2
N32: Fuel injector, cylinder 3
N33: Fuel injector, cylinder 4
N71: Idle Air Control (IAC) valve
N80: EVAP carbon canister frequency valve
N83: Fuel injector, cylinder 5
N84: Fuel injector, cylinder 6
N122: Power stage for ignition coils
N128: Ignition coil for cylinders 2 and 4
N156: Intake manifold change-over valve
N158: Ignition coil for cylinders 3 and 5
P: Spark plug connector (6x)
Q: Spark plug (6x)
S17: Fuse for G6
S19: Fuse for diagnostic connector
S72: Circuit breaker for N30, N31, N32, N33, N83, and N84
S73: Circuit breaker for G39, G108, N18, N80, and N156
S74: Circuit breaker for G70 and G74
Additional Signals
B8: Throttle valve signal (not pictured)
B9: Road speed signal (not pictured)
B10: Engine speed signal (not pictured)
B11: Fuel consumption signal (not pictured)
B12: Shift lever position signal (not pictured)
B13: Shift point signal (not pictured)
C10: A/C compressor signal (not pictured)
C12: Diagnostic signal for Rapid Data (K circuit)
C13: Diagnostic signal for Rapid Data (L circuit)
C14: Flash code signal
|
|
EGR Frequency Valve N18
|
|
An EGR Frequency Valve is connected to the intake manifold and is operated by the MPI
control unit. The frequency valve regulates the amount of vacuum supplied to the EGR
valve.
By regulating the amount of vacuum to the EGR valve, its opening position and the
amount of exhaust gas recirculated can be accurately controlled.
The valve is located under the air mass sensor next to the intake manifold changeover
valve.
|
|
Substitute Function
There are no substitute functions for the EGR frequency valve. If the valve does not
receive power or ground, exhaust gas recirculation will not occur.
Self-diagnosis
The ECU recognizes the following:
- Short circuit to positive
- Open circuit/short to ground
|
|